1000MT-X Battery Management

When too many electrical accessories are added to the vehicle, messy wiring is inevitable. Excessive wires connected to the battery may cause damage and poor contact at the battery terminals (shortened threads or stripped screw threads). Meanwhile, wire‑cutting splicing is often adopted to achieve unified ignition‑switch control, which brings certain safety risks. In addition, multiple electrical loads increase the standby power consumption of each device. Over time, this results in battery drain and shortens battery service life. This controller is specially designed to address these common issues.

The controller performs on‑off control by detecting the engine status. No wire cutting is required. Flexible and simple configuration meets various application requirements and enables unified management and control over the vehicle’s electrical devices. It features zero standby power consumption and fully cuts off power to all electrical accessories once the vehicle engine is turned off, eliminating battery drain problems.

As an independent unit separate from the vehicle’s original power supply system, this controller allows safe installation of various electrical accessories. It will not trigger fault codes on the ECU / ECM / BCM. Moreover, it prevents after‑sales disputes caused by vehicle damage from unauthorized wiring modifications, which would otherwise void your vehicle’s warranty rights.